Material and Color: This item features our 8019-Mist Grey Plush Cut Pile carpet. Please note that while the main product image may show a different color, the swatch image accurately reflects the correct color.Because we offer a wide variety of colors, please double-check your selection before ordering. Please request free samples if you are unsure of the color Vehicle Compatibility: This carpet will fit just like original carpet when installed correctly. This carpet is formed to fit a 1975-1980 GMC Standard Cab Truck 4 Wheel Drive 4 Speed Installation Notes: This automotive carpet is custom-formed but may require trimming and cutting holes to install. Please review the complete instructions provided in the description before starting. Unless specified otherwise, the jute insulation padding is heat-bonded to the underside, and the protective heel pad is pre-welded into its factory-correct position. Custom Manufacturing: This carpet features a standard, flexible polyethylene backing. If you prefer an upgrade to premium Massbacking, please contact us before ordering. Using a form that was cast directly from the original floor pan, each carpet is precision heat and pressure formed. When properly installed following the provided instructions, it will fit the contours of your original floor pan. Carpet Quality: All automotive carpets are Made in USA with Top Quality auto carpet materials. This carpet has a 1 year manufacturer warranty. This item will be made in color: 8019 - Mist Grey Plush Cut PileThis carpet will fit 1975-1980 GMC Standard Cab Truck, 4 Wheel Drive 4 Speed. Door sills are required to cover sides as the original did. Carpet will be made with standard flexible polyethylene backing. Contact us to upgrade to MassbackingUnless specified, the jute padding will be attached in the foot area of the carpetInstallation may require trimming around the edges and the holes may need to be cutThere is a large variety of colors available. Please request free samples if you are unsure of the color
PLEASE READ - Instructions may vary for multi-piece setsUnbox: Remove carpet from the box. Lay it flat, pop the formed contours back into place, and allow it to sit for a few hours. Verify the material and color are correctCompare: Lay your old carpet next to the new one to verifyTemplate: You may use the old carpet as a template for console and bolt hole cutsAlignment: Fold the new carpet in half from front to back. Place it in the vehicle, aligning the contours or another fixed factory starting pointsRoll and Cut: Roll the carpet forward, making cuts for brackets, shifters, and vents while ensuring the carpet remains aligned with your starting pointFirewall Fit: If needed, make a center cut at the firewall to allow the carpet to slide underneath the dashboardWork Outward: Repeat this alignment process, working your way from the center out toward the edgesFinal Trim: Once you are satisfied with the dry fit, perform your final trimming along the outer edges, seat belt mounts, and remaining holesPro Tip: If you choose to use an adhesive, apply a light brush-on or spray adhesive after a dry fit has been done
